[. . . ] W10665255B RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. [. . . ] Position mounting bracket against the wall in the cutout so that the V-notch of the bracket is 12½" (31. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket holes of the determined mounting method. If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position. NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard. WARNING Rear position Front position Diagonal (2 options) Wall Mounting Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Using the Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #10 x 1⁵⁄₈" (4. Move range close enough to opening to allow for final electrical connections. Move range into its final location, making sure rear leveling leg slides into anti-tip bracket. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Failure to follow these instructions can result in death or serious burns to children and adults. Measure the distance from the top of the cooktop to the bottom of the leveling legs. The leveling legs can be loosened to add up to a maximum of 1" (2. A minimum of ³⁄₁₆" (5 mm) is needed to engage the anti-tip bracket. NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs. When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final location, check that the antitip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation. NOTE: If a Trim Kit will be used, the top of the cooktop should be higher than the counter. See the Installation Instructions included with the Trim Kit for the correct height. Move range forward onto shipping base, cardboard or hardboard to continue installing the range using the following installation instructions. [. . . ] Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Warranty” section of the User Guide to contact service. [. . . ]